The Visionary Sound Company

Hook-up Wire

Figure 7 - Hook-up wire placement

Finally, you will need to pull apart the ribbon cable into it's individual colored wires.  Strip the ends of the colors as shown in the diagram and table below and insert them into the component side of the circuit board.  Solder them on the underneath as we have previously done.  Make sure no stray wisps of wire are exposed on the top side of the board as they are likely to short out and cause a problem

The battery leads will get soldered to the final two holes marked V- & V+ when we come to mount the circuit board inside the case.

Because the way colors sometimes display are subject to your monitor settings, I have included a table below which identifies which color should go to which connection.