The Visionary Sound Company

Wiring Everything Together

Wiring everything together is simplicity itself.  Just follow the diagram below.

Figure 8 - ClipCop Hook up diagram

If you place the separate halves of the case as in the diagram, you can scotch tape them together to stop them moving around independently.  This will make the hook-up process much easier.

Place the LED clip locking ring on the back of the LED clip before you bend and solder the leads.  The longer of the two LED leads (Anode) is bent over and soldered to the same lug of the ON/OFF switch as the violet wire.  The shorter of the two LED leads (Cathode) is bent down and out of the way and soldered to the blue wire  Note that the blue, red, and violet wires are actually continuous.  They have been separated in the diagram for ease of viewing.

Hook-up Photo

Try and make the wiring as neat as possible.  Neat wiring is the one thing that separates pro-gear form amateur projects.  I like to twist or braid (plat) the different groups of wires into looms.  This also cuts down on RF interference.